English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Utilisateur

Ahmed Aboushouk

À rejoins en date due:

Aug. 10, 2021

Points

330

Commentaire(s)

12

Questions votée(s)

0

Réponses votée(s)

0

Votes positifs

0

Votes contre

0

Votes reçus

0

Votes négatifs reçus

0

Activité récente

Questions demandée(s)

6

Question(s) répondue(s)

0

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question
ACTIVITÉ RÉCENTE QUESTION(S) DEMANDÉE(S)" QUESTION(S) RÉPONDU(S)" QUESTION(S) COMMENTÉE(S)"

06/12/2022

 Remote Starters Ahmed Aboushouk (330Pts.)

0

Renault Kadjar 2020 Evo All standalone

I have a Renault Kadjar 2020 with push button, I want to install Evo All as a standalone solution for remote starting the car, Renault Kadjar and Nissan Rogue Sport share their major components and are similar in a lot of aspects, they have the same BCM and same wiring sockets, I have followed the guide for Nissan Rogue sport and there are differences in the following : 1- OBD ignition ( pin 8 is empty ) 2- 24 Pin Black Socket ( Pin 19 is empty while Blue wire is on Pin 20 ) 3- 40 Pin black Socket ( Pin 9 is empty ) 4- Most of the Wiring Colors are different than the guide Please keep in mind that i have already used the same solution on a Nissan Qashqai ( similar to rogue sport ) but with a T harness and it worked My main concern now is to have a correct wiring guide for Renault Kadjar and i am confident that it will work
Connectez-vous pour répondre Voir 0 réponse(s)

05/12/2022

 Nissan Ahmed Aboushouk (330Pts.)

0

Fuse rating for EVO-ALL power supply

I am about to install EVO-ALL for Standalone installation ( without the T-Harness ) for a nissan Qashqai ( Rogue sport in CA ) with push to start ( Guide # 83931 )

S/N of my EVO-All is : 001A07026604

I have three main questions so i can complete the installation :

1- Fuse rating for the power supply of the module ( between B4 pin and 12v battery )

2- Diodes direction is confusing me as the Ignition A4 pin is an output pin which means that Current should flow from EVOALL to the car BCM pins while the Diodes direction says the opposite  ( cathode at top meaning current flows from BCM pins to EVOALL )

3- Which is more recommended for a way of control to disable remote starting when needed ( i cannot have Alarm functions beside remote starting for this vehcile ) where 2nd option would completey shut off the power to EVOALL :

- Adding ON/OFF switch on the Hood Pin A8( connecting other switch end to ground )

- Adding ON/OFF switch on B4 pin on the same line of the Fuse ( connecting other switch end to ground )

  Many thanks in advance for your support & cooperation
Connectez-vous pour répondre Voir 1 réponse(s)

12/11/2021

 Nissan Ahmed Aboushouk (330Pts.)

0

Alarm activation when locking with OEM Fob

I have an EVO ONE with alarm system activated ( with connected to the Horn ), I donot have any OEM alarm from the manufacturer, My car is nissan qashqai with push button. Alarm used to be activated when i locked the car using OEM fob or door button ( If i recall correctly ), Now it is only working when locking with RF kit remote ( crimestopper ) while it doesnot trigger the alarm when locking with OEM fob . Is there any programmable option that i did my mistake or i am missing to restore the orignial feature. I want the alarm to be activated whenever the vehicle is locked from any source ( door button or OEM fob or RF kit remote ) thanks in advance It is S/N : 001A07026604 and i am using a T harness
Connectez-vous pour répondre Voir 1 réponse(s)

08/09/2021

 Nissan Ahmed Aboushouk (330Pts.)

0

VALET mode from crimestopper REVO4.1 remote :: Turbo mode activation

I have an EVO-ONE for remote start and built in Alarm ( using the horn ) EVO-ONE S/N : 002B04198955 The setup is configured for a Nissan Qashqai ( rogue sport ) 2019 with a PTS ( using T harness ) I have installed the crimestopper REVO4.1 rf kit succesfully and i have two questions : 1- How to enter the Valet mode from the REVO remote ( their guide is very basic and did not mention how to do so , Though i discovered by luck that holding the trunk button would disarm the EVO only for temp time till i lock again but do not know how to trigger the Valet to stop the starter and alarm completely ) 2- I cannot find a way to activate turbo mode ( it is already enabled in option 19 with 2 minutes runtime ), while the engine is running and i am inside the vehicle, i press the remote start on Revo remote ,The Car acknowledge by 3 parking light flashes then if i press the ignition push button the car shutsdown ( while it should keep running and then i should leave the car and lock it to activate turbo for the 2 minutes ) I am stuck on the part that it shouldnot shutdown when i press the push button I tested also with the same procedure but without pressing the push button , the car keeps running for more than 5 minutes ( i believe it should be in idle mode and will shutdown after the full 15 minutes but i didnot test to wait for 15 minutes ) Sorry for the long description and thanks for your support
Connectez-vous pour répondre Voir 1 réponse(s)

14/08/2021

 Nissan Ahmed Aboushouk (330Pts.)

0

How to activate Evo All Alarm on a 2019 nissan qashai

I have successfully installed Evo All as a standlone setup with a T harness on 2019 nissan qashai with push to start I donot have a factory alarm installed I only have factory horn 1x chirp after lock from oem remote and no chirps for the unlock I searched and found that pin A4 in the evo ( green ) should go to the horn signal and to enable options G in the evo I see from my car guide that pin A4 is already in use for the Ignition so i cannot figure it out how the evo can control the horn I have enabled options G and nothing happened ( expected ) Please advise how can i add the evo alarm features to my current setup My evo s/n : 001A07026604
Connectez-vous pour répondre Voir 1 réponse(s)

13/08/2021

 Nissan Ahmed Aboushouk (330Pts.)

0

Nissan Qashqai 2019 Steering Lock Plug wiring

I have successfully installed standalone evo one for nissan qashqai 2019 with push to start When i remote start the vehicle and then enters inside it then when i press the Ignition so i can start diving, car refuses to accept ignition saying steering is locked and doesnot allow car to be on the ON position I have tried enabling door shutdown option and it actually shutdown car when any door is opened So in the current setup , i have to press brake after entering then it shutdowns then i start it normally again I saw something about steering lock plug connector but i donot know which wires in the A plug harrness to connect to ? I have a white/green wire but there is no white/red Please assist me as i want to start driving directly after entering the vehicle
Connectez-vous pour répondre Voir 1 réponse(s)

No results

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question

Support Technique

Recherchez parmi nos produits les plus populaires et les sujets d'installation disponibles dans notre section Questions et réponses.

En savoir plus
Téléchargez notre application de guides de dépannage étape par étape disponible pour iOS et Android ou parcourez notre version de bureau.

En savoir plus
Accédez à la plus grande base de données de schémas de câblage et de photos en ligne de l'industrie. Un jeton gratuit est fourni dans chaque boîte EVO-SERIES.

En savoir plus
Vous n'avez pas trouvé l'information que vous cherchiez ? Posez-nous une question en remplissant le formulaire de demande de support technique. Un spécialiste produit vous répondra sous peu.

En savoir plus
Des solutions de contrôle à distance et de connectivité à la fine pointe de la technologie au soutien technique haut de gamme, découvrez pourquoi vous devriez choisir les produits Fortin.

En savoir plus

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer